The image above is for illustration purpose only. The actual module may vary from the one presented here.
Module M-CON-WL-p is a component of the Ampio system. Required voltage to power the module is 11 — 16V DC. The module is controlled via CAN bus.
The module acts as a base station for wireless modules that communicate using the Ampio LoRa technology
Only one M-CON-WL-p module can be present in an Ampio building automation installation.
The device acts as a base station for the Ampio devices from the WL group that communicate via the Ampio LoRa wireless interface. As a base station, the device distributes information between wireless modules and other building automation devices.
As part of installation activities, each Ampio LoRa device must be paired with a module that acts as a base station. To do this, use the Smart Home CAN configurator software to enter the M-CON-WL-p module into a search mode for modules from the WL group. When the search mode is active, press the pairing button on the wireless module that you are trying to pair three times. If the operation is successful, the found device will appear on the list of paired wireless modules within the Smart Home CAN configurator software.
The dimensions of the module enable its installation in a standard junction box. In order to start the module, it must be connected to the CAN bus. The bus of the Ampio system consists of four wires - two for power and two for communication between the modules.
A cable, which constitutes an antenna, is led out of the casing of the device.
Only one M-CON-WL-p module can be present in an Ampio building automation installation.
On the front of the module there are signalling LED indicators. The redl LED with the label CAN indicates the status of communication on the CAN bus:
The module is programmed with the use of the Ampio Designer software. It allows you to modify the parameters of the module and define its behaviour in response to signals directly available to the module as well as general information coming from all devices present in the home automation bus.
It is not recommended to use more than 8 Ampio LoRa wireless modules per one base station module. Installing more modules may result in excessive load on the wireless network and improper functioning of the system.
Dimensions expressed in millimeters.
The dashed lines mark the areas where the device connectors or its other elements can be located.
Click to enlarge and open in a new tab.
